"R L ENTERPRISES"

Supplier: R L ENTERPRISES

Aluminium die-cast clamps with three rubber covered jaws and nickel plated screws.

Supplier: R L ENTERPRISES

Heater, Gas cartridges, 220 g, Butane/propane

Supplier: R L ENTERPRISES

Double bosshead made from cast alloy.

Supplier: R L ENTERPRISES

Rectangular retort bases with M10 threaded hole in centre of short side.

Supplier: R L ENTERPRISES

The burner is constructed with a gas control needle valve. Specially designed conical mixing chamber is incorporated, which allows the burner to give off a very hot flame.

Supplier: R L ENTERPRISES

Adapter manufactured out of aluminium with boss to fit scaffold feet.

Supplier: R L ENTERPRISES

Alloy/zinc plated steel construction.

Supplier: R L ENTERPRISES

Steel, with blue acrylic finish. Rectangular stand base with 10 mm diameter threaded bore, 1,5 mm deep on side.

Supplier: R L ENTERPRISES

Steel, with blue acrylic finish. Rectangular stand base with 10 mm diameter threaded bore, 1,5 mm deep in the middle of the plate.

Supplier: R L ENTERPRISES

Retort rods with M10 thread, made of zinc plated steel.

Supplier: R L ENTERPRISES

Alloy die-cast, aluminium shaft. This clamp accepts articles up to 85 mm diameter. Actuated by nickel-plated brass pummels and blue plastic headed nickel-plated steel twin screw.

Supplier: R L ENTERPRISES

These lab jacks are manufactured to close tolerances from aluminium with stainless steel operating screw.

Supplier: R L ENTERPRISES

Nickel plated diecast aluminium alloy. Three prong clamp with nickel plated brass pummels and blue plastic headed nickel plated steel twin screw pivoting on a stainless steel pin.

Supplier: R L ENTERPRISES

Bossheads made from nickel plated cast alloy.

Supplier: R L ENTERPRISES

This rubber covered chain with cork lined jaws will support articles from 0 to 150 mm diameter.

Supplier: R L ENTERPRISES

Aluminium.