R-2160

RED, HIGH TEMPERATURE SILICONE ELASTOMER

Description

  • Two-part, red, pourable silicone system
  • 10:1 Mix Ratio (Part A:B)
  • Cures at room temperature or rapidly with heat
  • High tear strength and good physical properties

Applications

  • As a high temperature adhesive / sealant
  • Ideal for use in potting connectors, cable harness breakouts, molded high voltage terminals, seals and gaskets due to its high physical strength
  • For applications requiring an operating temperature range of -65°C to 315°C (-85°F to 600°F)

Product Details

Property Average Result
Cure System Platinum
Viscosity 280,000 cP (280,000 MPa*s)
Durometer 20 Type A
Appearance Red
Cure 30 minutes / 150 °C
Dielectric Strength 500 volts/mil (19.5 kV/mm)
Elongation 625 %
Mix Ratio 10:1
Non Volatile Content 100 %
Operating Temperature -65 °C / 315 °C
Specific Gravity 1.2
Tear 140 ppi (24.69 kN/m)
Tensile 750 psi (5.17 MPa)
Volume Resistivity 100,000,000,000,000 ohmcm
Work Time 1.5 hours
Comment Iron Red, flowable legacy high performance elastomer at elevated temperatures.

Bonding

The diverse line of NuSil® adhesives specifically designed for electronic component assembly increases production throughput without sacrificing performance.

Read more

Save to favorites

The test data shown for this material is the average value for typical properties. All of these properties may not be tested on a lot to lot basis and cannot be used to draft specifications. Please contact NuSil for assistance and recommendations in establishing limits for product specifications.