Description
- Two-part, heat curable silicone disperson
- Cures via addition-cure chemistry
- 1:1 Mix Ratio (Part A: Part B)
Applications
- Suitable for dip casting and heat-curing of thin elastomeric films
- Low viscosity makes dispersions ideal for use as sprayable coatings
NuSil Technology’s MED10-6600 shall not be considered for use in human implantation for a period of greater than 29 days.
Product Details
| Property | Average Result |
|---|---|
| Cure System | Platinum |
| Viscosity | 400 cP (400 mPa*s) |
| Non Volatile Content | 35 % |
| Durometer | 25 Type A |
| Appearance | Translucent |
| Cure | 30 minutes / 25 °C 45 minutes / 75 °C 135 minutes / 150 °C |
| Elongation | 750 % |
| Mix Ratio | 1:1 |
| Refractive Index | 1.46 |
| Solvent | Xylene |
| Stress at Strain | 325 psi / 300 % (2.24 Mpa / 300 %) |
| Tear | 145 ppi (25.57 kN/m) |
| Tensile | 1,200 psi (8.28 MPa) |
| Comment | 1.46 R.I. |
The Strongest Silicone Elastomer Ever Developed
Dr. Jim Lambert, NuSil® Director of Research and Development, Biomaterials, introduces our breakthrough material that has a tensile strength of up to 50% greater than existing silicone elastomers on the market.
The test data shown for this material is the average value for typical properties. All of these properties may not be tested on a lot to lot basis and cannot be used to draft specifications. Please contact NuSil for assistance and recommendations in establishing limits for product specifications.