Description
- Two-part, high tear strength silicone elastomer
- Medium durometer silicone
- Cures with heat via addition-cure chemistry
- Has a non-tacky surface and no volatile by-products or peroxide residues
- Strained through a 400-mesh screen (minimum)
- 1:1 Mix Ratio (Part A: Part B)
Applications
- For a wide variety of fabrication techniques for the healthcare industry including: molding, calendering and extruding
NuSil Technology’s MED-4050 shall not be considered for use in human implantation for a period of greater than 29 days.
Product Details
| Property | Average Result |
|---|---|
| Durometer | 50 Type A |
| Tensile | 1,500 psi (10.34 MPa) |
| Elongation | 985 % |
| Tear | 250 ppi (44.09 kN/m) |
| Appearance | Translucent Gray |
| Cure | 10 minutes / 115 °C |
| Cure Rate Scorch | 1.1 minutes |
| Cure Rate T90 | 2.6 minutes |
| Cure System | Platinum |
| Mix Ratio | 1:1 |
| Plasticity | |
| Specific Gravity | 1.16 |
| Stress at Strain | 300 psi / 200 % (2.07 Mpa / 200 %) |
| Work Time | 3.5 hours |
| Comment | High Tear Strength |
Encapsulation Technology
Watch our CareSil team explain the breakthrough Encapsulation Technology and demonstrate how easy it is to create transformative formulations with CES.
The test data shown for this material is the average value for typical properties. All of these properties may not be tested on a lot to lot basis and cannot be used to draft specifications. Please contact NuSil for assistance and recommendations in establishing limits for product specifications.