9343 Results for: "VARIAN"
Columns, MicroBore
Supplier: VARIAN
The microbore columns are ideal for use with detectors requiring low flow rates such as some mass
spectrometers and with capillary LC systems. Easily accommodates high temperatures for better selectivity and resolution between impurities and the target oligo.
Expand 14 Items
Resin, PL-FMPB, StratoSpheres™
Supplier: VARIAN
PL-FMPB resin, 1% DVB, 1,4 mmol/g, 150 - 300 μm, 1 kg
Expand 1 Items
Tuning and performance standards for LC/MS
Supplier: VARIAN
Agilent offers a range of tuning and performance standards for LC/MS.
Expand 1 Items
HPLC columns, OmniSpher™ C18
Supplier: VARIAN
OmniSpher™ is an ultra-high bonded silica designed for the analysis of mixtures containing either acidic or basic functionality that would normally tail on more traditional columns.
Expand 6 Items
Capillary columns, VF-Xms
Supplier: VARIAN
VF-Xms delivers the ultimate in sensitivity and signal-to-noise ratio, and is the low bleed, more polar alternative.
Expand 8 Items
GC columns, J&W CP-1301
Supplier: VARIAN
Agilent JW CP-1301 is a medium polarity column ideal for the analysis of herbicides, pesticides, and many pharmaceutical products.
Expand 3 Items
Solid phase extraction disks, Empore®
Supplier: VARIAN
Empore® extraction disks provide a high flow rate solution for large volume sample preparation. By increasing the diameter of the disk used, the disk surface area available for sample passage increases, resulting in better solvent flow rates through the disk.
Expand 1 Items
Bulk material, Hydromatrix™
Supplier: VARIAN
SLE products use a broad-performance, inert diatomaceous earth sorbent for rapid, general sample preparation.
Expand 2 Items
Solid phase extraction cartridges, Bond Elut™ C2
Supplier: VARIAN
Bond Elut™ C2 is a fairly non-polar sorbent because of the short chain length of the functional group. C2 is often used during the process of method development if analytes are retained too strongly on a C8 or C18 phase. The polarity of C2 is slightly lower than a cyano phase for polar interactions.
Expand 10 Items
Biocompatible adapters
Supplier: VARIAN
Biocompatible adapter, 1/16” to 1/8”, PEEK, with fittings, PEEK
Expand 2 Items
Capillary columns, CP-TAP CB for triglycerides
Supplier: VARIAN
CP-TAP CB is available in special fused silica for maximum column strength at temperatures up to 370 °C, or UltiMetal capillary for the ultimate robustness.
Expand 2 Items
Well plate tubes for Bond Elut™ PH plates
Supplier: VARIAN
Round, VersaPlate well plate tubes, PH, 100 mg
Expand 1 Items
Vacuum trap assembly, A584
Supplier: VARIAN
This vacuum trap eliminates the possibility of drawing fluids into the vacuum pump that may be detrimental to it.
Expand 1 Items
Capillary columns, CarboBOND and CarboPLOT P7
Supplier: VARIAN
These carbon-based PLOT columns offer a simplified solution for ASTM D 2505, which describes the measurement of ppm CO and CO₂ in ethylene and propylene streams.
Expand 6 Items
Capillary columns, CP-Sil PAH CB UltiMetal
Supplier: VARIAN
The UltiMetal CP-Sil PAH CB column combines the advantages of a highly thermo-stable stationary phase with UltiMetal as the column material.
Expand 1 Items
Capillary columns, VF-5ms
Supplier: VARIAN
VF-5ms is a highly inert 5% phenyl-methyl column for increased sensitivity, accuracy and instrument uptime.
Expand 38 Items
Solid phase extraction cartridges, Bond Elut™ SCX
Supplier: VARIAN
Bond Elut™ SCX is a strong cation exchanger with a very low pKa. Although the pKa is similar to Bond Elut™ PRS, the presence of the benzene ring in the functional group increases the potential for non-polar interactions. This non-polar characteristic becomes particularly important when conducting ion-exchange from aqueous systems, where selectivity towards compounds exhibiting cationic and non-polar character is seen.
Expand 24 Items
Solid phase extraction cartridges, Bond Elut™ Florisil
Supplier: VARIAN
Florisil is a magnesia-loaded silica gel, extremely polar in nature and ideal for the isolation of polar compounds from non-polar matrices.
Expand 15 Items
Solid phase extraction cartridges, Bond Elut™ DEA
Supplier: VARIAN
Bond Elut™ DEA bears some resemblance to Bond Elut™ NH₂ in its properties but with a slightly lower capacity as an anion exchange sorbent. DEA has a moderately non-polar character due to the alkyl side chains on the amino functionality. These groups still afford a medium level of polarity, higher than C₈ but less polar than C₂ or CN-E.
Expand 11 Items
Flash cartridges, Mega Bond Elut™
Supplier: VARIAN
Flash cartridges for the purification of organic compounds, and also for scale-up, solid phase extraction.
Expand 24 Items
Solid phase extraction cartridges, Bond Elut™ SPEC
Supplier: VARIAN
SPEC SPE solid phase extraction cartridges available in standard straight barrel tube format, offering flexibility in sample size. Use on any standard vacuum manifold such as the Vac Elut 20 or SPS 24.
Expand 25 Items
Vacuum manifolds, Vac Elut™ 20
Supplier: VARIAN
The Vac Elut™ 20 vacuum control valve, vacuum gauge, and quick release valve are mounted on the lid, away from the corrosive waste stream and within convenient reach. The solvent-resistant PP rack is available in a variety of sizes to accommodate collection tubes commonly used in sample preparation.
Expand 5 Items
Solid phase extraction cartridges, EnvirElut™
Supplier: VARIAN
EnvirElut™ sorbents are specially designed for the extraction of a wide range of compounds from aqueous matrices. EnvirElut™ PAH and Pesticides are available in standard SPE straight barrel cartridges, which can be used on conventional vacuum manifolds such as the Vac Elut SPS 24.
Expand 6 Items
Capillary columns, CP-Wax™
Supplier: VARIAN
The CP-Wax™ lines of chemically bonded columns offer a broad range of selectivities for method optimisation. The backbone of this series stationary phases is made of a polyethylene glycol.
Expand 47 Items
Particle traps for use with PLOT columns
Supplier: VARIAN
Though highly stabilised, it is impossible to guarantee that no particles will dislodge from the column wall. When used in valve-switching applications, the use of a particle trap can prevent scarring of the rotors.
Expand 6 Items
Well plate tubes for Bond Elut PBA plates
Supplier: VARIAN
VersaPlate well plate tubes, PBA, 100 mg
Expand 1 Items
96-Well plates, VersaPlate™
Supplier: VARIAN
VersaPlate allows you to process more samples in less time with less waste in a 96-well format.
Expand 5 Items
96-well plates, round well, Bond Elut™
Supplier: VARIAN
Solid Phase Extraction (SPE) plate, 96-round well plate, Bond Elut™, Silica sorbents (particle size 40 μm), LMS, 200 mg
Expand 44 Items
Tubing for peristaltic pump
Supplier: VARIAN
Pump tubing, PVC, For aqueous samples