You searched for: Coating Testers

Supplier: Industrial Physics

These thickness gauges are designed for the measurement of coatings of painting, enamel, galvanizing, metalising and plating on steel.

Supplier: Industrial Physics

This inspection gauge is a destructive precision tool for inspection and thickness measurement, on single or multiple coats, on virtually all substrates, including wood, plastics, metals.

Supplier: Industrial Physics

The (Hull) roughness gauge is a compact system to measure the average Hull roughness (AHR) of sea going vessels, especially for ship operators, ship builders, ship repairers and coating manufacturers.

Supplier: Industrial Physics

The Colorbox is used to provide the illumination conditions for any visual inspection at a 45° angle.

Supplier: Industrial Physics

This thickness gauge is designed for the measurement of non magnetic coatings include paint, enamel, plating, hot-dip galvanising on steel. A small magnet can be placed with pin-point accuracy on small parts and on peaks and valleys.

Supplier: Industrial Physics

Impact tester used to determine the impact resistivity and flexibility of materials.

Supplier: Industrial Physics

These thickness gauges are designed to measure the thickness of metallic and non-metallic materials (aluminium, titanium, plastics, ceramics, glass, plastics). It can monitor pipes and vessels for loss of thickness due to corrosion or erosion.

Supplier: Industrial Physics

Hammer used to test the quality of concrete, as well as other construction materials, for analysing resistance.

Supplier: Industrial Physics

This replica tape is specifically designed to measure blasted surfaces. By placing the Tqc replica tape on the surface and rubbing over it, the Rt (total roughness) or peak-to-valley height of the profile can be taken and measured.

Supplier: Industrial Physics

Combination gauge equipped with two different tips: Sharp needle for surface roughness and round tip for coating thickness.

Supplier: Industrial Physics

This apparatus is designed to detect of coating porosity in dielectric (insulation type) coatings on conductive substrates, including concrete.

Supplier: Industrial Physics

Test panels are used to enhance reproducibility of physical and chemical tests. Each panel is equipped with a hole for hanging and handling.

Supplier: Industrial Physics

Dust test kit allows assessment of the quantity and size of dust particles on surfaces prepared for painting.

Supplier: Industrial Physics

The PosiTest DFT measure coatings on all metals - The DFT Fe measures non-magnetic coatings on steel while the DFT Combo measures both non magnetic coatings on steel and non conductive coatings on aluminum and brass.

Supplier: Industrial Physics

Plastic (or aluminium) thickness combs to be used as a record of wet film thickness measurements, in 30 steps.

Supplier: Industrial Physics

Hexagonal/octagonal precision measuring comb made of heavy stainless steel - The high-grade stainless steel will not be affected by acid or base elements.