"Splitter, Humboldt"

Supplier: Trajan Scientific and Medical

Fixed outlet splitters for capillary columns
A fixed outlet splitter is recommended for splitting the flow from a capillary column between two detectors. The kit consists of a special Glass Lined Tubing (GLT™) splitter union, tubing and all ferrules required for installation.

Supplier: Bohlender

3-Way stopcock with stainless steel housing and integrated control module.

Supplier: VWR Collection

For dividing sieved material into representative test sieve samples.

Supplier: Trajan Scientific and Medical

SilFlow™ microchannel device (MCD) options for three-port GC splitters, four-port GC splitters and a Deans' switch MCD, perfect for multi-dimensional analyses. SilFlow™ can be incorporated into the system without impacting the chromatography.

Supplier: Bohlender

Display unit to control the b.safe Splitter, which is available as an option in combination with connected fill-level sensors in b.safe Waste Caps and b.safe System Waste Caps.

Supplier: Agilent

These splitters are used for splitting an injected sample from a single injector into two columns and on to two detectors.

Supplier: VWR Collection

Accessories for VWR® Sample Splitters

Supplier: Restek

Flow splitters with fluid resistor technology eliminate the adjustments to the capillary tubing for optimising split ratio with wide range of interchangeable resistors.

Supplier: VARIAN

Select Permanent Gases/CO₂ is a set of two parallel columns that combines CP-Molsieve 5 Å for permanent gas analysis and CP-PoraBOND Q for CO₂ analysis.

Supplier: Avantor Fluid Handling

Sensors shut down the pump drive in less than 1 second in the event of fluid leak or tubing failure.

Supplier: Retsch GmbH

Spare 8 l receptacle, For: RT 25, RT 37.5, RT 50 and RT 75

Supplier: MACHEREY-NAGEL

Universal capillary glass connectors, Y splitter, Glass

Supplier: PerkinElmer

Liners protect GC columns against column contamination. These glass split and splitless inlet liners promote full vaporisation of samples, minimise mass discrimination, and achieve accurate and reproducible results.

Supplier: UPCHURCH SCIENTIFIC

Designed to accurately split and control the low flow stream of a single incoming supply.

Supplier: Thermo Fisher Scientific

This SilFlow 3-port device allows column switching in GC-MS without the need to vent.

Supplier: Retsch GmbH

Sample splitters are used for the simple dividing and reduction of bulk materials of all kinds. Ideal for the on site reduction of sample material. Depending on the particle size, material and particle size distribution, the opening width of the passage should be 2,5 to 3 times greater than the diameter of the largest particle (particle size factor).