Hai cercato: Reagenti per Western Blotting

Supplier: Thermo Fisher Scientific

The Pierce™ Fast Western Blot Kit, SuperSignal™ West Femto Substrate contains optimised reagents that shorten the time to perform a typical Western blot from 4 hours to ~60 minutes.

Supplier: G-Biosciences

Perfect-FOCUS™ is based on quantitative precipitation and concentration of protein solutions using UPPA™ (Universal Protein Precipitation Agent) and has been specifically developed for preparing lower conductivity protein samples for iso-electric focusing gels. Perfect-FOCUS™ is designed to clean and remove interfering agents from protein samples and concentrate protein solutions that give poor protein spot resolution during 2D electrophoresis.

Supplier: Merck Millipore (Oncogene)

This Western-Re-Probe™ reagent is validated for use in immunoblotting.

Supplier: Cytiva

Each kit contains the detection reagent, HRP conjugated antibodies, and blocking agent sufficient for detection of 1000 cm² membrane.

Supplier: Thermo Fisher Scientific

For chemiluminecent HRP-based detection of western blotting systems. It is soluble in most polar organic solvents but is insoluble in water.

Supplier: Thermo Fisher Scientific

QuantaRed™ Enhanced Chemifluorescent HRP Substrate contains chemical enhancers to increase the fluorescent yield and sensitivity of 10-acetyl-3,7-dihydroxyphenoxazine (ADHP) chemifluorescence.

Supplier: PanReac AppliChem

The CheLuminate-HRP PicoDetect is a complete kit with ready to use reagents for chemiluminescent detection of immobilised proteins (Western blot) or immobilised nucleic acids (Southern or Northern blot), conjugated with horseradish peroxidase (HRP) directly or indirectly.

Supplier: Thermo Fisher Scientific

The Fast Western Blot Kits, SuperSignal™ West Dura provide reagents and protocol for reliable and rapid, 1 hour chemiluminescent Western blotting at femtogram levels of sensitivity. These complete Fast Western Blot Kits requires minimal hands on time and yield results comparable to classical Western blotting with SuperSignal™ West Dura Chemiluminescent Substrate. This substrate produces a signal that is detectable using photographic or other imaging methods. The developed blots can be repeatedly exposed and stripped of the primary antibody and reprobed. The complete kit contains all the reagents necessary to block and probe a Western blot with mouse or rabbit primary antibody.

Supplier: Rockland Immunochemicals

These Chemiluminescent Western Blot Kits allow for the detection of primary polyclonal or monoclonal antibodies provided by the user. After protein separation and transfer, the membrane is probed with primary antibody. Detection of the membrane-bound primary antibody-antigen complex is achieved by the addition of a secondary antibody conjugated to the enzyme horseradish peroxidase. The enzyme reacts with a specialised formulation of luminol, an extremely sensitive, non radioactive substrate that emits light and allows visualisation using X-ray film or other imaging methods, including highly sensitive CCD cameras and imaging systems. Because of the extremely high sensitivity of the kit, primary and secondary antibodies can be used at greater dilutions. Primary antibodies currently diluted 1:1000 using an ECL™ substrate is the equivalent of a 1:5000 dilution using the FemtoMax™ substrate.

Supplier: G-Biosciences

Kingdom blot is prepared using total protein extracted from a variety of species, where whole species is not available the whole liver lysate is used. These blots can be used to identify similar proteins in other species, including human, chicken, frog, worm, Drosophila, yeast, Aspergillus, E. coli, Rhizobium and green algae.

Supplier: Cytiva

AlkPhos Direct™ Labelling and detection systems are based on the rapid, direct labelling of DNA or RNA probes with thermostable alkaline phosphatase. AlkPhos Direct™ combines the convenience of direct enzyme labelling (no blocking or antibody stages) with those of alkaline phosphatase detection (long light output and high sensitivity).

Supplier: Cytiva

The appearance of streaks that distort 2-D electrophoresis maps is a common problem, occurring most frequently when running gels that contain regions greater than pH 7,0. Increased sample load, increased length of the IPG strip, or using a narrower pH gradient worsens the problem. Extra spots on 2-D gels, caused by non specific oxidation of proteins, is another difficulty encountered when running gels containing basic regions. Both streaking and non specific oxidation result in poorly resolved protein patterns and reduced reproducibility between electrophoresis runs.

Supplier: Cytiva

ECL Direct Nucleic Acid Labeling and Detection Systems are based on the direct labeling of DNA or RNA probes with horseradish peroxidase (HRP) in a simple 20 min chemical reaction. The resulting probe can be used without purification. Detection is achieved by generation of light via the HRP-catalyzed breakdown of luminol.

Supplier: Cytiva

ECF™ substrate for Western blotting

Supplier: Cytiva

ECL Direct Nucleic Acid Labeling and Detection Systems are based on the direct labeling of DNA or RNA probes with horseradish peroxidase (HRP) in a simple 20 minute chemical reaction. The resulting probe can be used without purification. Detection is achieved by generation of light via the HRP-catalyzed breakdown of luminol.

Supplier: Cytiva

Chemiluminescence detection reagent for detection of high to medium abundant proteins.

Supplier: Cytiva

Cy™ fluorescent amidites for incorporation of Cy3, Cy3,5, Cy5, Cy5,5 fluorescent dyes at any position in an oligonucleotide during synthesis.

Supplier: Cytiva

Pharmalyte® carrier ampholytes, prepared by the co-polymerization of glycine, glycylglycine, amines and epichlorohydrin, are available in five broad-range and four narrow-range pH intervals.

Supplier: Cytiva

Amersham™ ECL™ Prime is a highly sensitive Western blotting detection reagent characterised by stable signal emission, allowing for the possibility of repeated exposures and making it easier to process several blots in the same experimental run. Amersham™ ECL™ Prime delivers a detection system that is sensitive, stable, precisely quantitative across a wide dynamic range of protein levels, and conservative in its consumption of expensive antibody reagents. The high performance of Amersham™ ECL™ Prime is due to the presence of an enhancer in the reagent, increasing enzyme turnover, and thereby significantly increasing both signal intensity and duration. The light signal is further intensified by the addition of a catalyst.

Supplier: Cytiva

Amersham ECL Blocking Agent is for blocking nitrocellulose and PVDF membranes to be used with Amersham ECL, Amersham ECL Prime and Amersham ECL Select Western Blotting Detection Reagents

Supplier: Cytiva

Amersham ECL Select is a high sensitivity reagent for chemiluminescent Western blotting detection.

Supplier: Cytiva

CypHer5E is a red-excitable, pH-sensitive cyanine dye derivative that is minimally fluorescent at a basic pH and maximally fluorescent at an acidic pH.

Supplier: Cytiva

CyDye™ Mono-Reactive Maleimide Fluorescent Dyes are intensely fluorescent and highly water soluble, providing significant advantages over other existing fluorophores.

Supplier: MP Biomedicals

This antibody diluent is compatible with common stabilising compounds at pH 7,3.

Supplier: Cytiva

Amersham ECL detection reagent uses enhanced luminol-based detection suitable for all routine confirmatory Western blotting experiments.

Supplier: Cytiva

Amersham ECL Prime Blocking Reagent is blocking Amersham Protran NC and Amersham Hybond PVDF membranes used with Amersham ECL start, Amersham ECL, Amersham, ECL Prime, Amersham ECL Select and Amersham ECL Plex.

Supplier: Cytiva

ECL Direct Nucleic Acid Labeling and Detection Systems are based on the direct labeling of DNA or RNA probes with horseradish peroxidase (HRP) in a simple 20 minute chemical reaction. The resulting probe can be used without purification. Detection is achieved by generation of light via the HRP-catalyzed breakdown of luminol.

Supplier: Uptima

Substrate optimised for the detection of immobilised HRP in Western, Southern, Northern and dot blot applications.

Supplier: Serva

IEF carrier ampholyte, SERVALYT™, pH 5 - 7, PGM, analytical grade