You searched for: Distillation Components

Supplier: Wards

High quality glass crow reciever useful for oil distilation and tar tests.

Supplier: United Scientific Supplies

Quick setup for distillation

Supplier: CHEM SCIENCE INC CA

These solvent still high vacuum valves have PTFE covers on the shaft and tip.

Supplier: DWK Life Sciences (KIMBLE)

Column features a [ST] 14/10 joint and indentations over the entire length to optimize vapor-liquid contact.

Supplier: Chemglass

With [ST] joints on both top arms and on lower inner joint

Supplier: Chemglass

Adapters have a #7 Chem-Thread at the top for a vacuum-tight seal of plain stem thermometers.

Supplier: Corning

These PYREX® 60° angle distilling connecting adapters have a 24/40 Standard Taper outer joint at the upper end and inner 24/40 Standard Taper joints and on the sidearm and lower joints

Supplier: Chemglass

Adapter is placed above flask to prevent carry-over of reactions which have a tendency to foam.

Supplier: Chemglass

Designed to maintain distilled solvents in an inert atmosphere.

Supplier: Chemglass

Radial style distillation receiver allows four flasks to be progressively filled.

Supplier: DWK Life Sciences (KIMBLE)

These columns are plain fractionating column with indents to support packing.

Supplier: Corning

Distallation receiver to determine the amount of dilution in crankcase oils when gasoline has been used as fuel. Receiver design keeps heat-sensitive materials away from the hot base of the flask. Receiver has a [ST] 24/40 top outer joint and a [ST] 24/40 sidearm inner joint.

Supplier: Chemglass

Simple distillation head with a condenser sealed to the adapter at a 75° angle.

Supplier: Kemtech America

Centrifuge tube shaped receiver with an upper standard taper joint.

Supplier: Kemtech America

With the Vigreux column vacuum jacketed to improve distillation performance.

Supplier: Kemtech America

Joint on side tube accommodates 25 mm immersion thermometer.

Supplier: G.S.C. INTERNATIONAL, INC.

No two liquids have exactly the same boiling point. Therefore it is possible to separate any mixture of two liquids by raising the temperature of the mixture to a point where one of the liquids will boil but the other will remain liquid.

Supplier: Chemglass

Distillation kit for 10 and 20 L reactor systems

Supplier: Wards

High quality Vigreux column used to separate vaporized mixtures of liquid compounds with close volatility.

Supplier: Chemglass

These adapters for distillation systems are designed with standard taper outer joint at the top and inner joints on the bottom and sidearm.

Supplier: Chemglass

Graduated distilling receivers with a standard taper outer joint on top.

Supplier: Chemglass

Dean-Stark receiver used for determining the water content of various materials.

Supplier: Chemglass

This Dean-Stark receiver is designed for azeotropic distillations using solvents that are heavier than water.

Supplier: Chemglass

Designed for use with small quantities where hold-up between the flask and receiver must be kept to a minimum

Supplier: Chemglass

Adapters have a standard taper outer joint at the top of the main tube for use with jointed thermometers.

Supplier: Chemglass

Distilling heads are available with vigreux indentations.

Supplier: United Scientific Supplies

Vigreux distilling columns for cooling and condensing.

Supplier: Chemglass

Distilling receivers used to determine the water content in material.

Supplier: Kemtech America

This grease-free solvent still is supplied with the head only.

Supplier: CHEM SCIENCE INC CA

Access port has threaded 14/10 joint to accept a PTFE-lined silicone septum with a compression cap (supplied).