You searched for: Distillation Components

Supplier: SP Industries

This short path distillation head features Vigreux indentations in the bottom portion of the stem to improve efficiency.

Supplier: Kemtech America

Rotating distillation receiver allows four fractions to be collected.

Supplier: Ace Glass

This distillation receiver is for use where separate fractions are desired without disturbing the distillation pressure

Supplier: Ace Glass

This distillation receiver is for use where separate fractions are desired without disturbing the distillation pressure

Supplier: Ace Glass

This Vigreux distillation column has a male drip tip on the joint of the Claisen side arm, and a [ST] 10/30 joint for a 25mm immersion thermometer

Supplier: Ace Glass

The column length in millimeters (listed below) refers to the effective length of the column as measured from the lowest to the highest indent of the column

Supplier: Ace Glass

This column has a reinforced outer [ST] joint at top and a ground inner [ST] joint at bottom

Supplier: Ace Glass

Adapter's top joint is a combination cap, thread and joint to accommodate and seal other microscale apparatus.

Supplier: Ace Glass

Especially useful when heavier-than-water solvents are employed

Supplier: Ace Glass

Modified Bidwell & Sterling type with overflow to allow excess solvent to return to boiling flask

Supplier: Ace Glass

Arsenic Limit Test apparatus as described in the European Pharmacopeia chapter 2.4.3.

Supplier: Ace Glass

Distilling head sits on top of your vapor path column. Has condenser side arm with drip tip.

Supplier: DWK Life Sciences (KIMBLE)

For the determination of free sulfite and a reproducible portion of the bound sulfites in food, such as the carbonyl addition products.

Supplier: Ace Glass

This adapter features a 75° side arm.

Supplier: Kemtech America

The three inlets of this adapter allow for multiple entries into a single neck flask.

Supplier: Ace Glass

This is an excellent all-purpose receiver for general distillation work

Supplier: Ace Glass

Microscale Hickman still head is used to carry out micro-sample fractional distillations

Supplier: Ace Glass

Distilling trap adapters are placed above flask to prevent carryover of reactions that have a tendency to foam.

Supplier: Ace Glass

This adapter is designed for connecting a distilling column with a vertical condenser.

Supplier: Ace Glass

This apparatus is useful for separating higher boiling liquids that require a short flask-to-column distance to prevent excessive condensation

Supplier: Ace Glass

Graduated to 125mL in 1mL subdivisions

Supplier: Ace Glass

This Hennion Design distillation head is used for variable reflux ratio, and can be operated under vacuum

Supplier: Ace Glass

Full-size standard taper 24/40 jointed, low-holdup, short-path still is available unjacketed or jacketed with indents

Supplier: Ace Glass

This Hempel distillation column has a [ST] 24/40 reinforced outer joint at top, a [ST] 24/40 inner joint at bottom, and a perforated glass disc for packing support

Supplier: SP Industries

Designed for oils lighter than water, this distilling apparatus is made of borosilicate glass and consists of a Clevenger-type trap with a Standard Taper 24/40 outer joint on top and same size inner joint the sidearm

Supplier: SP Industries

This Kjeldahl distilling apparatus is made of borosilicate glass.

Supplier: DWK Life Sciences (KIMBLE)

Rotation of cold finger condenser allows collection of distillate or return to flask.

Supplier: DWK Life Sciences (KIMBLE)

Provide dual entry into a variety of flasks.

Supplier: DWK Life Sciences (KIMBLE)

These distillation receivers are ideally suited for the determination of water content in organic solvents.

Supplier: DWK Life Sciences (KIMBLE)

Inlet and outlet tubes are curved in opposite directions within the bulb