You searched for: Distillation Receivers

Supplier: Ace Glass

This receiver has an upper joint at a 105° angle

Supplier: Ace Glass

This borosilicate glass connecting tube features an 0-4 Hi-Vac valve assembly for setting up Schlenk lines

Supplier: Kemtech America

Rotating distillation receiver allows four fractions to be collected.

Supplier: DWK Life Sciences (KIMBLE)

Inlet and outlet tubes are curved in opposite directions within the bulb

Supplier: DWK Life Sciences (KIMBLE)

Modified distilling receiver with [ST] 24/40 joints, siphon return arm, and a sidearm bridge that equalizes pressure.

Supplier: Kemtech America

Rotating cow receiver allows four flasks to be progressively filled.

Supplier: Ace Glass

Especially useful when heavier-than-water solvents are employed

Supplier: Ace Glass

Modified Bidwell & Sterling type with overflow to allow excess solvent to return to boiling flask

Supplier: Ace Glass

This Dean-Stark moisture test receiver is suitable for ASTM D 95 and E 123

Supplier: Ace Glass

This moisture test receiver is used to determine the water content in petroleum and bituminous material

Supplier: SP Industries

Calibrated “to contain” at 20°C, these distilling receivers are used for determination of water in various materials by distillation with a solvent that is not miscible with water.

Supplier: Ace Glass

Short-path still distribution receiver with #11 Ace-Thred vacuum port.

Supplier: Chemglass

Distillation receivers feature an overflow tube.

Supplier: Corning

Receivers, made of PYREX® brosilicate glass, are designed for determining water by distillation.

Supplier: Chemglass

Cow type design has three receivers 45° apart.

Supplier: Chemglass

Distilling receivers used to determine the water content in material.

Supplier: Chemglass

This Dean-Stark receiver is designed for azeotropic distillations using solvents that are heavier than water.

Supplier: Chemglass

Graduated distillation receivers feature a 4 mm three way stopcock.

Supplier: Chemglass

Radial style distillation receiver allows four flasks to be progressively filled.

Supplier: Chemglass

Graduated distilling receivers with a standard taper outer joint on top.

Supplier: Kemtech America

Used in distillation of very small amount of distillate at lower temperature with high efficiency

Supplier: Chemglass

Distillation receivers feature efficient cooling.

Supplier: Chemglass

Dean-Stark receiver used for determining the water content of various materials.

Supplier: Kemtech America

Centrifuge tube shaped receiver with an upper standard taper joint.

Supplier: Kemtech America

With the outer and inner joints at 135° angle.

Supplier: Corning

PYREX®, borosilicate glass.

Supplier: Kemtech America

Designed for microscale application.

Supplier: Kemtech America

With jacketed uptake tube vacuum to improve distillation performance

Supplier: Corning

This PYREX® tube is approximately 200mm long and may be used for simple semi-micro vacuum or atmospheric distillation, either as a reaction flask or a receiving tube

Supplier: Corning

Distallation receiver to determine the amount of dilution in crankcase oils when gasoline has been used as fuel. Receiver design keeps heat-sensitive materials away from the hot base of the flask. Receiver has a [ST] 24/40 top outer joint and a [ST] 24/40 sidearm inner joint.