You searched for: Chemical Fume Hoods

Supplier: Labconco

Guardian Airflow Monitors are designed to continuously monitor airflow through Labconco fume hoods

Supplier: Labconco

Protector XL floor-mounted laboratory hoods with horizontal-sliding sashes are suitable for general chemistry applications and have the dimensions required for over-sized equipment.

Supplier: Labconco

The AtmoSense™ moisture monitor is designed for general purpose trace moisture detection as low as 0 to 20 ppm.

Supplier: Labconco

Testing confirms the Protector XL floor-mounted laboratory hoods with vertical-rising sashes meet the SEFA-1 standard of a low velocity, high performance hood and may be operated as low as 60 fpm.

Supplier: Labconco

The AtmoSense™ Oxygen monitor is designed for general purpose trace oxygen detection as low as 1 ppm.

Supplier: Kewaunee

These modified epoxy resin worktops are available with or without a 5.1cm (2") diameter vent hole

Supplier: Labconco

Designed for classroom use, these lightweight hoods feature an epoxy-coated aluminum frame with tempered safety glass front sash, sides, rear baffle, and top.

Supplier: Labconco

Guardian Digital Airflow Monitors alert the operator to low airflow conditions

Supplier: Labconco

Solid epoxy work surfaces are 3.2cm (1¹/₄") thick, 65.7cm (25⁷/₈") deep, and dished to contain spills.

Supplier: Labconco

The Basic™ hood is ideal for rooms with ceilings below 2.4 m, 8" and for shallow countertops.

Supplier: Labconco

ClassMate™ laboratory hoods are designed to meet the needs of instructional laboratories.

Supplier: Labconco

Specifically designed to solve unique ventilation problems, this canopy hood vents nontoxic materials such as heat, steam, and odors from large or bulky equipment.

Supplier: Labconco

Ideal for rooms with shallow countertops or ceilings below 8', these hoods are constructed of sturdy, epoxy-coated steel both inside and out.

Furnished with a 3/16" tempered safety glass counterbalanced sash and duct collar, the hoods ensure your students’ safety. A removable front panel and air foil, vapor-proof interior light, and two-piece adjustable baffle make for easy access and convenient use.

The right side fixture is factory prepared to accept up to three service fixtures, one duplex electrical receptacle, and air monitor. The side wall is factory prepared for a wall-mounted cupsink with turret. Hoods are available in two model types – Basic 47 Hoods with a 4' nominal width are designed as an individual lab station,

Basic 70 Hoods are 6' in width and spacious enough to accomodate numerous samples or workstations.

Both models are available with or without a blower. Blowers may be mounted in or above the hood, or on the roof. Basic 47 hoods that include a blower have a 3/4 hp motor.

Note: Worksurface, base cabinet, and blower are required for operation, and sold separately.

For assistance, contact your local sales representative

Supplier: Labconco

For use with Basic™ 47, Basic 70, Fiberglass 30, Protector® XStream®, Protector Premier™, Protector ClassMate®, Protector PVC Perchloric Acid, Protector Stainless Steel Perchloric Acid, Logic+, Logic, Cell Logic, PuriCare Procedure Stations and Protector Radioisotope laboratory hoods

Supplier: Eagle Group

Stainless steel laboratory exhaust canopies are used to exhaust laboratory work spaces.

Supplier: WaterSaver Faucet

Since isotope hoods do not have interior access panels, they require a front load fitting that can be accessed from outside the hood