You searched for: Graticules, Reticles and Grids

Supplier: Electron Microscopy Sciences

The NG12 is particularly useful since the array of globes and circles are conveniently close to where the particles pass.

Supplier: Electron Microscopy Sciences

Lacy carbon film provides support without interfering with transmission electron microscopy observation.

Supplier: Electron Microscopy Sciences

Thin Bar Grids have been developed using a new technology to produce ultra-fine grids with thinner cross bars than regular grids.

Supplier: Electron Microscopy Sciences

Please note that for calibration the circles and globes will represent particles smaller in diameter by the magnification of the objective.

Supplier: Electron Microscopy Sciences

This graticule consists of a number of short lines with interruptions as long as the lines.

Supplier: Electron Microscopy Sciences

Veco grids offer superior handling characteristics.

Supplier: Electron Microscopy Sciences

A reliable support specimen grid source. Features well-defined grid bars, maximum open area, and a matt/shiny side. Each grid is individually inspected.

Supplier: Electron Microscopy Sciences

These pinholes are prepared from pure copper foil, 3 mm in diameter, and 25 microns thick.

Supplier: Electron Microscopy Sciences

Used for measurement of large objects in conjunction with a graduated mechanical stage, and for alignment as well.

Supplier: ELECTRON MICROSCOPY SCIENCE

The continuous ultrathin film on lacey film allows for the thinnest support film that still has adequate strength to withstand specimen preparation. The film (less than 3 nm thick) lies across a carbon lacey film supported by a 200, 300, or 400 mesh grid. This product is ideal for looking at nanotubes, virus particles and other small particulate material.

Supplier: Electron Microscopy Sciences

By employing a rectangular mesh the support value of the grid has been increased, offering a value intermediate between the most commonly used grid (200 Lines/") and (300 Lines/"). Each grid rectangle is asymmetrical having different outlines in all four corners. This allows for the orientation of the grid to be determined at microscopic levels.

Supplier: Electron Microscopy Sciences

QUANTIFOIL® is a carbon film for electron microscopy or low-energy electron point source microscopy.

Supplier: Electron Microscopy Sciences

QUANTIFOIL® is a carbon film for electron microscopy or low-energy electron point source microscopy.

Supplier: Electron Microscopy Sciences

Mainly used to estimate the three-dimensional surface areas or the surface density of a component in a given volume, when the component does not have a random orientation.

Supplier: Electron Microscopy Sciences

Thin Bar Grids have been developed using a new technology to produce ultra-fine grids with thinner cross bars than regular grids. The result is equally firm specimen support but with 40% more open area for viewing maximum specimen surface area.

Supplier: ELECTRON MICROSCOPY SCIENCE

CVD Graphene TEM support films are supported by lacey carbon film on a 300 mesh copper TEM grid. The graphene film appears as a near-transparent to light-grey film on the surface of the Lacey Carbon mesh on a red-brown colored copper TEM grid.

Supplier: Electron Microscopy Sciences

QUANTIFOIL® is a carbon film for electron microscopy or low-energy electron point source microscopy.

Supplier: Electron Microscopy Sciences

These two new SEM grids are designed to aid in the identification and localization of SEM specimens when placed on standard SEM stubs. The SEMF2 allows for easy characterization and analysis of particles and suspensions. The SEMF3 uses an alpha-numeric index, allowing up to 25 predetermined specimens to be fixed and then located in a SEM.

Supplier: Electron Microscopy Sciences

Reticle A is designed for general laboratory use (5 mm long, with 0.1 mm divisions) and reticle B (⁴/₁₆ " long, ¹/₆₄" divisions) is most frequently used in textiles or electronics, and where measurement in mils is required. Reticle C (5000 µm long, with 50 µm divisions) is calibrated in microns and helpful for pesticide droplet size measurements or anywhere measurements in microns are required.

Supplier: ELECTRON MICROSCOPY SCIENCE

Silicon Nitride TEM Window Grids perform well under harsh lab conditions.

Supplier: Electron Microscopy Sciences

Gauge pairs occupying a field of view of 10 mm. Each gauge is proportional to its adjacent number. The approximate size of the smallest pair is 0.1 mm.

Supplier: Electron Microscopy Sciences

Provides support without interfering with tranmission electron microscopy observation.

Supplier: Electron Microscopy Sciences

These UltrAuFoil gold holey carbon films will reduce the movement of frozen specimens during imaging and used in electron cryomicroscopy.

Supplier: Electron Microscopy Sciences

Supplier: ELECTRON MICROSCOPY SCIENCE

QUANTIFOIL® is a carbon film for electron microscopy or low-energy electron point source microscopy.

Supplier: ELECTRON MICROSCOPY SCIENCE

QUANTIFOIL® is a carbon film for electron microscopy or low-energy electron point source microscopy.

Supplier: ELECTRON MICROSCOPY SCIENCE

Graphene Oxide (GO) support film is a super thin (<1 nm), naturally hydrophilic layer placed over the Holey, Lacey or Quantifoil support film on copper or gold grids.

Supplier: Electron Microscopy Sciences

Veco grids are the most rigid grids.

Supplier: Electron Microscopy Sciences

A reliable support specimen grid source.

Supplier: Electron Microscopy Sciences

R 2/4