You searched for: Afdichtingen

Supplier: Restek

A ring inlet seal greatly improves injection port performance as it stays sealed even after repeated temperature cycles, without retightening the reducing nut. This seal features two soft Vespel® rings, one embedded in its top surface and the other embedded in its bottom surface. These rings eliminate the need for a washer and ensure very little torque is needed to make a leak-tight seal.

Supplier: Restek

Mechanical Seals, Silver seal for split/splitless injector

Supplier: Greiner Bio-One

AMPLIseal™ is a self-adhesive sealing film notable for its low autofluorescence, in particular in the wavelength range critical for Real Time PCR. It consists of a thick PP film coated with a transparent acrylate adhesive. The adhesive layer is protected by a peelable polyester film. The strongly adhering acrylate adhesive provides reliable sealing, thereby minimising evaporation but without influencing the PCR reaction or the fluorescence measurement.

Supplier: Greiner Bio-One

VIEWseal™ is an adhesive sealing film coated with a silicone adhesive, which only sticks when the film surface is pressed on. The film is easy to work with, even when wearing gloves (the film does not adhere to gloves).

Supplier: RATIOLAB

Afdichting microplaat, Adhesive film/foil/tape (96/384 wells), Single sheet/mat/strip, Cover film, Polyethyleen peeling-afdekfilm, PE, Niet steriel

Supplier: DWK Life Sciences

A comprehensive line of 96-well microplates for chromatography, the Plate Sampling System™ uses closures familiar to those who work with standard chromatography vials.

Supplier: Greiner Bio-One

SILVERseal™ is a heat resistant, cold-resistant and pierceable aluminium foil, which is suitable for both PCR applications and sample storage.

Supplier: Restek

Inlet seals are used at the base of the Agilent 5890/6890/7890 GC injection port, which contacts the sample and should be changed frequently to prevent adsorption of active compounds. In addition, septum fragments and sample residue accumulate on the disk surface, requiring disk replacement.

Supplier: Thermo Fisher Scientific

Thermo Scientific™ Rheodyne™ replacement rotor seals for injectors made of ETFE to maintain the performance of Rheodyne™ sample injectors for high-performance liquid chromatography (HPLC).

Supplier: Restek

Silver seals for Thermo Scientific TRACE, 8000, 8000 TOP and Focus.

Supplier: RATIOLAB

Closures for 96-Well Deep-Well-Plates Low-Profile, 1,2 ml. Made of thermo-plastic elastomer (TPE).

Supplier: DIVERSIFIED BIOTECH

This durable, heat and solvent-resistant LDPE stretch film has substantial advantages over common laboratory stretch films.

Supplier: Restek

PEEK washers for ASE 200

Supplier: FISHER CONTAINER

Clear LDPE, amine-free antistatic film ideal for partitioning during retrofitting or construction. Specially formulated to reduce particulate contamination.

Supplier: Restek

Graphite O-rings for PerkinElmer Auto SYS XL or Clarus GCs with PSS injector.

Supplier: ELKAY

SealPlate breathable sealing film is a hydrophobic rayon film with end tabs, using medical grade adhesives.

Supplier: DIVERSIFIED BIOTECH

Afdichting microplaat, Adhesive film/foil/tape (96/384 wells), Single sheet/mat/strip, Breathe-Easy pre-cut, self-adhesive sheets, Sealing film for cell culture plates, Breathe-Easy, PU, Steriel

Supplier: HAWKSLEY AND SONS

For sealing capillary tubes. The dry end of the filled tube is pressed into the Cristaseal with a twisting motion producing a firm seal with flat boundaries. The tray may be used as a carrier for tubes prior to centrifuging.

Supplier: Restek

These O-rings are made of graphite. Ideal for Bruker/Varian 1177 injectors.

Supplier: DIVERSIFIED BIOTECH

Breathe-EASIER micropermeable membranes are ideal for cell growth, concentrating samples, and gas exchange. Formatted with an easy to use finger tab, membranes are precut to fit a variety of tube sizes. Membranes are gamma irradiated to ensure sterility and are free of cytotoxins.

Supplier: KING DISPOSABLES

Food wrap cling film of eight micron thickness.

Supplier: Restek

Replacement inlet seal washers

Supplier: JUCHHEIM Laborgerate GmbH

PTFE, Lid gasket, PTFE, for reaction vessels 2000 ml capacity

Supplier: Restek

Silicone O-Rings for PerkinElmer Auto SYS XL or Clarus with CAP injector.

Supplier: Aesculap

Seal to secure the container lock against uncontrolled opening.

Supplier: Aesculap

Veiligheidsafdichting, Tamperproof lock with orange steam indicator

Supplier: Restek

O-rings, max. temperature 250 °C

Supplier: Restek

O-rings for APEX liners

Supplier: SciLabware

Silicone rubber sheathed with PTFE.

Supplier: Greiner Bio-One

These adhesive seals offer an alternative to heat seals or sealing mats. EASYseal™ is a transparent adhesive film designed to cover microplates to protect samples from evaporation and contamination. It is suitable for routine laboratory use, including ELISA applications. BREATHseal™ is a gas permeable, pierceable membrane coated with an acrylic adhesive. It is ideal for bacterial, yeast and cell culture applications, assuring the protection of cell contents from contamination whilst maintaining oxygenation.