Vous avez recherché : Étalons

Supplier: LGC Standards PROMOCHEM

This standards reference material is intended to use in the determination of constituent elements in clay and material of similar matrix. These powdered clay was air-dried, ball-milled and blended to ensure homogeneity.

Supplier: Restek

The weathered materials indicate the percent weight loss from the original material. Prepared from a single source (one refinery) product.

Supplier: Restek

100-octane, low-lead fuel used in piston-type aircraft.

Supplier: WTW

Standard de cuivre, Copper standard solution, 1000 mg/L

Supplier: Restek

These solutions are prepared from a single-source (one-refinery) product.

Supplier: Restek

Subsurface degradation of fuel oil spills can be estimated by examining the ratios of C17/pristane and C18/phytane. To assist in identifying these four compounds from the complex fuel oil analysis, Restek offer a product that contains these compounds for retention time determination.

Supplier: WTW

Phosphate standard solution, 1000 mg/L

Supplier: Restek

The mix consists of diesel fuel #2 composite, mineral oil.

Supplier: Cole-Parmer

Standard solutions are used for calibrating conductivity cells.

Supplier: CPACHEM

Conductivity standard, 2500 µS/cm, Température de réference: 25 °C

Supplier: Thermo Orion

Carbon dioxide standard for ISE calibration, 0.1M NaHCO₃, Orion™, Applications: ISE Calibration

Supplier: LGC Standards PROMOCHEM

Conductivity standard, 147 µS/cm

Supplier: WTW

Chromate(VI) standard solution, 1000 mg/L

Supplier: Mettler - Toledo

A slight change in temperature usually has a big impact on the conductivity value of a standard solution. A table on every bottle label indicates the conductivity values at the most common measurement temperatures.
During calibration the meter automatically references to this table for temperature compensation. If possible, calibration and measurements should be performed at the same temperature

Supplier: YSI ENVIRONMENTAL

Conductivity standard, 50 000 µS/cm

Supplier: Endress+Hauser

Precision solution referred to SRM of NIST.

Supplier: HAMILTON BONADUZ

Conductivity standards with stability of ±1% - guaranteed over a lifetime of up to three years.

Supplier: CANNON INSTRUMENT

CANNON silicone viscosity standards are intended for use with rotational viscometers only.

Supplier: CANNON INSTRUMENT

These certified standards are useful for calibration and verification procedures.

Supplier: WATERS

Standards for Ion Pair Chromatography, Paired-ionic chromatography reagent B7, heptane sulfonic acid

Supplier: WATERS

Standard for spectrophotometer calibration, UV wavelength accuracy solution (erbium perchlorate)

Supplier: LGC Standards PROMOCHEM

This solution is intended for use as a certified reference material in the determination of water in motor oil by Karl Fischer titration.

Supplier: GONOTEC

Calibration standard, Osmolalité: 300 mOsmol/kg, 10× 1 ml

Supplier: Advanced Instruments

Calibration standard is used to check the perforance of osmometer and test methods.